Workshop

Notes from the bench: camera angles, lighting, tools and the machines coming next.

Block diagram of Arduino, ULN2003 and 28BYJ-48 motor
ArduinoStepper motor

28BYJ-48 stepper + ULN2003 with Arduino: wiring, code and common problems

How to wire the 28BYJ-48 stepper to a ULN2003 board and Arduino, AccelStepper code for continuous speed and fixed angles, and why it buzzes but won't turn.

Tolerance test block with holes 0.1 mm apart
3D printing tipsCAD design

3D printing tolerances for shafts and bearings: clearance, press fit and test prints

Printed hole sizes for Ø8 and Ø6 shafts, 688 bearings and LM6UU bushings, clearance vs press fit, teardrop holes for horizontal bores and how to print a tolerance test.

A 15-tooth and 75-tooth gear pair, module 1.2
3D printing tipsCAD design

Designing 3D-printed gears: module, tooth count, profile shift and backlash

How to choose module, tooth count and ratio for 3D-printed gears, why small pinions need profile shift, how much backlash to leave and print settings for clean teeth.

Roadmap of upcoming mini machines
PlansIdeas

FoxBench DIY roadmap: 13 mini machines to build

The mini machines FoxBench DIY plans to build with 3D printing and Arduino, how they were picked and the order of the first seven videos.

Size chart for M3, M4, M5 and M6 brass heat-set inserts
3D printing tipsInserts

Heat-set inserts in 3D prints with a soldering iron: hole sizes, temperatures, tips

How to install M3–M6 brass heat-set inserts in 3D-printed parts with a soldering iron. Hole size table, PLA/PETG temperatures and common mistakes.

Diagram of five camera positions around the workbench
FilmingLighting

Filming hands-only DIY videos: 5 camera angles, lighting and backdrop

How the FoxBench DIY bench is set up to film builds with only hands in frame: five camera angles, GoPro and iPhone settings, two lights and a blue backdrop.